T-Shirt Forums banner

Problem with just one color

1883 Views 3 Replies 2 Participants Last post by  sben763
HELP anyone if you know!!! I just bought a CFS system for my epson 1400 printer. I had a very hard time getting this to work but after hours, it started printing. But now all of a sudden, the yellow will not print and I dont know how to fix it. I have a sporting event that i am suppose to be heat pressing at in 30 minutes but can't do anything without this working. please reply if you know how to fix. Thanks
1 - 4 of 4 Posts
Take the syringe at the top of the cartridges inside printer. Pull the priming plug and pull up till you get a ml of ink in syringe. If you didn't prime them when you got the system you should do all of them. Discard any ink you pull out then do a head cleaning or 2.
Take the syringe at the top of the cartridges inside printer. Pull the priming plug and pull up till you get a ml of ink in syringe. If you didn't prime them when you got the system you should do all of them. Discard any ink you pull out then do a head cleaning or 2.

I have the big separate bottles on the outside of the printer. Are you saying that i need to pull the part inside the printer? When you say prime do u mean vacuum pump the air from each tube?
I have the big separate bottles on the outside of the printer. Are you saying that i need to pull the part inside the printer? When you say prime do u mean vacuum pump the air from each tube?
Where the cartridges would normally go where the tubes hook up there should be a plug. You will remove the plug and use syringe to remove air. This should have been done at start up epson print heads should never be run dry.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top