It is possible that your material went offline. Is your material straight in your cutter? Do you notice anything with the material going off to one side?
Problem with cutting master 3
Hi All,
I'm Having some trouble with my Graphtec ce6000-60.
I'm using cutting master 3, my problem is that the cutter stops in middle of the cutting, and just can't figure out why, any help would be much appreciated
Thank's
I'm Having some trouble with my Graphtec ce6000-60.
I'm using cutting master 3, my problem is that the cutter stops in middle of the cutting, and just can't figure out why, any help would be much appreciated
Thank's
1 - 4 of 4 Posts
No !! everything is ok since I have experience working with Graphtec 3000-60, and never had that kind of problem, I did set the cutter to factory setting but still the same prob, make me loose lot of vinl.
Were you able to get this resolved?
1 - 4 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
T-Shirt Forums
A forum community dedicated to T-shirt merchants, professionals and enthusiasts. Come join the discussion about graphics, commerce, dyes, prints, collections, guides, displays, styles, scales, equipment, accessories, reviews, classifieds, and more!
Full Forum Listing
Top Contributors this Month
View All
TABOB
110 Replies
into the T
32 Replies
screenxpress
17 Replies
Recommended Communities
