T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
124 Posts
A very cheap option would be to build up the pocket with card board.....don't laugh...cut a few pieces, the width and depth of the pocket. Slip them into the pocket and the raised area will be a perfect printing spot.
It will let that area get the pressure it needs and the heat to correctly apply the graphic. Remember though, it's cardboard, I wouldn't use it over and over and over..........

For a long term solution, silicon pads can be cut into smaller sections. try doing a google seach on platen silicon pads and your in business............
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top