T-Shirt Forums banner

printer not centering

1622 Views 2 Replies 3 Participants Last post by  YoDan
I have yet another question. When I select my standard 15" x 20" platen on the rip, I then center it. But when I print it is about 2 inches off center. I've been trying to correct the problem, but am lost...any ideas?
1 - 3 of 3 Posts
Drew,

Give me a call at the office when you get a chance so we can see how you're printing and how to send the job with the proper settings.
I have yet another question. When I select my standard 15" x 20" platen on the rip, I then center it. But when I print it is about 2 inches off center. I've been trying to correct the problem, but am lost...any ideas?
In your design software do you have your page setup using 17" wide?
Dan
"HAPPY PRINTING"
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top