T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
We just started getting in natural (color) shirts (using Anvil 980 - 100% ringspun cotton). We have been using the regular DTG pre-treat on these shirts but recently had a customer bring one back after washing because the area that was pretreated turned gray after the wash. We are not sure if it was just that 1 shirt (something went wrong when we treated it) or if it just happens (we are going to run a test today). My bigger question is... do we even need to pretreat the Natural color shirts? If we set it up to print as a white shirt (no white ink needed) then will the colors still look good when printed?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top