Joined
·
9,952 Posts
I have seen several posts about pressing a transfer onto uneven material like the front of a polo shirt where the buttons get in the way. Well, the only thing I had available was a few mouse pad blanks.
I took the blank, put a teflon sheet over it, put the shirt over that and set the pressure for the same as the mouse pad and it seemed to work pretty well.
Any thoughts on why I shouldn't do this?
I was thinking of cutting a few up to make a sleeve and pocket template.
I took the blank, put a teflon sheet over it, put the shirt over that and set the pressure for the same as the mouse pad and it seemed to work pretty well.
Any thoughts on why I shouldn't do this?
I was thinking of cutting a few up to make a sleeve and pocket template.
