T-Shirt Forums banner
1 - 4 of 4 Posts

44 Posts
Discussion Starter · #1 ·
I'm new to this heat transfer stuff.

I just got a GeoKnight JetPress 14. I'm using Jet Dark transfer paper on black shirts. The transfers were printed on an Epson photo printer.
Transferred as per instructions for 15 seconds at 350-degrees.

The transfers went fine but there's like a ghost image the size of the press platen base on the shirt as well. I used a teflon cover sheet over the transfer paper and its cover sheet.

What's going on?
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.