T-Shirt Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter #1
Hi All, It seems when I only pre-treat the area just bigger then a left chest logo placement on a gray shirt I see staining from the pre-treat.... I also see this when I do a navy shirt, there is a darker outline where I sprayed the pre-treat. On Lighter shirts I dilute to 50/50 and on dark I use 100%.
 

·
Registered
Joined
·
37 Posts
not to be a [email protected]$$, but why are you pretreating a white shirt? in regards to the question, have you washed the garments and the "stain" stills persists? more than likely it will come off in the wash
 

·
Registered
Joined
·
29 Posts
Discussion Starter #3
LOL... I don't pre-treat white shirts. This is a seele gray shirt. I needed to do an underbase to make the red look red. When I printed without underbase it was too dark. I did wash this a few times and the stain will not go away.

 

Attachments

·
Registered
Joined
·
37 Posts
it's hard to see from the pic....did it look like this after you pressed it? i've had issues with pressure....it has to be just right it seems on the lighter shirts....
 
1 - 7 of 7 Posts
Top