[Icecold730]

Hello all. I am cutting out some of my first designs from the Signcut software to my Copam 2500. I look at the design preview of the cut to try to ensure accuracy of my origin point on my plotter and the point that Signcut will begin cutting but it seems like I can never achieve a constant understanding! When I begin the cut where I believe I should the vinyl ends up spitting out the back end. I would hope that I could just set my origin at the bottom left most area of the loaded vinyl and that there was some way of telling the software that this is the point of no return so that the cuts move away and to the right of this point. Can someone explain what I'm doing wrong in simple terms?

 

[Icecold730]

I resolved this issue. But thanks for the support I guess.

 

[scuba_steve2699]

what was the solution? It may help someone else that has a similar or identical issue and sees this post.