T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Ok...still stuck.

I just finished replacing the ribbon cable, and printhead for manual cleaning (on my some china DTG) and I got error 00010037, but I try to replug the cable, and it back normal again, but when I start to print the result was bad.I am not sure where to start looking.

I'm wondering if printhead is damage?:(

Any help would be appreciate,
here I attached the print results


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.