T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
HEY ALL

NEED HELP !!!

OWN DTG M2 BED NOT LOADING PROPERLY.


WHILE LOADING BED IT INSTANTLY SHOWS PRINT READY AND THEN THIS HAPPENS. ALSO ON SCREEN IT COMES IN BETWEEN COVER OPEN AND LEVER
IT GOES ALL THE WAY IN THAN COMES OUT HALF WAY AND MEDIA END ERROR SHOWS ON SCREEN.

I CLEANED SENSORS BUT NOTHING.

ALSO POWER BUTTON TURNS TO BLUE.

THN MANUALLY I PULL THE BED SLOWLY AND COVER OPEN COMES TO SCREEN AND LIGHT CHANGES TO GREEN AFTER A WHILE... BUT THN AGAIN IF I LOAD THE BED SAME MEDIA END ERROR AND BED IS STUCK AS SHOWN IN PIC ATTACHED..

PLEASE IF ANY1 CAN HELP. MY DEALER IS NO LONGER WORKING WITH DTG AND NO HELP FROM HIM :( DUNNO WHAT TO DO....:mad:

THANKS IN ADV

HEMEN.
Did you ever figure what was causing the error? My printer is doing the same thing.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top