T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
456 Posts
Discussion Starter · #1 · (Edited)
I have a job for 100+ sleeve prints, I need to cut a platten, does anyone know the correct size for sleeves. It seems it might be 3.5" to 4". I went ahead and made one at 4" I think it will be fine. I hate to beat a dead horse but on these shirts I will be placing a left chest logo. Sizes vary from youth small to adult 3x, would the best way to do this is to do all youth first, then move up in size and move the platen for each size or is it best to leave the platen alone and slide shirts side to side to get logo in position. Thanks, Mark
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.