[jag001]

Has anyone been able to solve either of the following and if so, HOW???

Run USB-only CR630 on native Mac OS X 10.6 or later

Run USB-only CR630 using Flexistarter and Windows XP in Parallels as a Virtual Machine


I want to use my iMac for both design and cutter control - not a mac and a pc next to each other.... any help would be appreciated!

 

[royster13]

From my reading on various forums, running cheap cutters on Mac is a challenge....I am not sure if there is answer somewhere but you might search the various forums....

You can start here at : www.t-shirtforums.com

There is also:
Signs 101 Home - Signs 101
USCutter Forum
VinylForum.org - Index

Good luck....

 

[reeceb36]

Hi,

p-cut should be fine with mac.

you want to use ct630, you will need signcut pro.
if you have the ftdi chip set you wont need any adapter to run it also.