T-Shirt Forums banner

PCB Reset Question on PR1000

534 Views 0 Replies 1 Participant Last post by  suzyq
I have a PR 1000 and a question.
When I go into the Main Board Test screen on A/D test section.
I have received a PCB reset message and cannot remember whether the LL is for setting the largest hoop size and the S is for the setting smallest hoop size.....please help! Thank you!
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.