T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I flushed out the lines and replaced dampers and when I turn on my printer, the LCD light came on and then went off. No power to printer, found 1 fuse on the motherboard on rear right side and replaced it but still no power so there more the 1 fuse ? If not any idea what the problem could be ? Note: I only disconnected the wires on the printhead as the instruction showed and they all went back on and seeded with no problem
Thank you for your time
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top