T-Shirt Forums banner
Cancel

newbie needs help! viper conveyor belt won't move

954 Views 1 Reply 2 Participants Last post by  Jinxplay, 
M
I just purchased a used dtg viper. I went over the printer before buying it and everything worked fine. I have it set up and i'm getting ready to run my first nozzle check and now the conveyor belt won't raise or lower! It went up and down fine before but maybe during transportation something got bumped or moved?? I made sure nothing was in front of the laser sensor and it turns green if I put something in front of the laser. I can't get the conveyor to go up or down by using the control panel. Is there a fuse for the conveyor motor or a wire harness I should check? any help would be greatly appreciated
Reply
Save
Like
1 - 2 of 2 Posts
J
the buttons are very hard to press, just press with a little force and in circles, to check for the bed, block the sensor and the bed will star lowering automatically,

i press the button like a switch and usually works
Reply
Save
Like
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
T-Shirt Forums
A forum community dedicated to T-shirt merchants, professionals and enthusiasts. Come join the discussion about graphics, commerce, dyes, prints, collections, guides, displays, styles, scales, equipment, accessories, reviews, classifieds, and more!
Full Forum Listing
Explore Our Forums
Screen Printing General T-Shirt Selling Discussion Graphics and Design Help Member Introductions Heat Press and Heat Transfers
Top