T-Shirt Forums banner

New Member

51 views 2 replies 2 participants last post by  TuKool 
#1 ·
Hey all. I have been lurking here for a while. Gained a ton of info and knowledge. Have now acquired equipment and started a home business.

Great forum. Greatly appreciated.
 
#3 ·
I have a GCC Expert cutter and Flex Heat heat press. Purchased from Flex Heat, obviously. As learned on this forum, I know Roland and Graphtec are the preferred machines. But for starting up, I felt GCC was a good compromise of value and cost. So far, They work great.

I plan to do apparel, wall graphics and phrases, and graphics and lettering for vehicles, store fronts, etc.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top