[Chad Barfield]

How can I access the menu at startup to fix my sensors? I keep getting a remove paper error upon startup and I cant figure out a solution. All of my cables are good, replaced all the boards, checked all remaining active sensors and still getting error. The only thing I can think to do is access the menu and make sure everything is set properly. Due to the error I cant access the menu. Any suggestions. Thanks!

 

[hitthespot]

holding the pause, down arrow and right arrow buttons down while turning on the machine will get you to the setup menu. Can't tell you where to go from there. Hope that helps.

 

[Chad Barfield]

Found out how to fix this problem. The motherboard has to be replaced.