T-Shirt Forums banner
1 - 1 of 1 Posts

124 Posts
Discussion Starter · #1 ·

Right, so upon start up I instantly get the "NO MNT TANK" error message.

I have replaced:

Ribbon cables to tank sensor & sub board.
Tank Sensor
Sub Board
All Ribbon Cables from Sub Board to Motherboard
Pretty much all ribbon cables from motherboard to all other boards
The right hand ink cart ribbons to the sub board.

None of them make a difference to the error message.

My only thoughts are that one of the changed cables is still not doing its job and needs replacing, which seems odd, but might be the only suggestion.

Has anyone got any better understanding of what might cause the error message to persist in light of these facts, so I can drill down my fault diagnosis?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.