Joined
·
81 Posts
Hey everyone.
Not sure if too many people know this machine, or what I should do with the current situation at hand.
I hit the Panel B control Wire with a box and it pushed slightly into the machine. Machine turned off and stopped running.
When I turned it back on, my control panel lights up, the LED board does not and the heads are non-responsive, not sure if it is because it was in the middle of sewing or not.
The buttons make noise, but do not seam to clear or thread trim.
I took a look at the wire, and two of the small wires leading to the pins were split. Even after splicing them, nothing.
Is my machine dead, or is there anything I should be looking for?
Please any help is appreciated. I am in tears right now as if I lose this, I lose my business that I only recently have been able to get sales going.
Not sure if too many people know this machine, or what I should do with the current situation at hand.
I hit the Panel B control Wire with a box and it pushed slightly into the machine. Machine turned off and stopped running.
When I turned it back on, my control panel lights up, the LED board does not and the heads are non-responsive, not sure if it is because it was in the middle of sewing or not.
The buttons make noise, but do not seam to clear or thread trim.
I took a look at the wire, and two of the small wires leading to the pins were split. Even after splicing them, nothing.
Is my machine dead, or is there anything I should be looking for?
Please any help is appreciated. I am in tears right now as if I lose this, I lose my business that I only recently have been able to get sales going.
