T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi Forum,

Basically I bought this vinyl cutter (Creation PCUT PRO II 730mm), managed to create the stand using my badly translated instructions, installed all the software and drivers that came with the software and hit a problem.

Vinyl cutter will not talk to the computer (Vista). FlexiStarter software obviously will not work as is old version. Was given no instructions as to how to get the vinyl cutter to talk to the computer... Tried to put SD card into vinyl cutter to avoid the problem, but don't know how to get it to recognise that either.

: (

Any help would be greatly appreciated.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.