T-Shirt Forums banner

21 - 25 of 25 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #21
i'm back!
i just replaced all my dampers and am flushing with distilled water...i believe all lines are working, but the lines to the waste container seem to be possibly clogged a bit...
is there a way to clean these...
i am flushing with warm distilled water hoping that will help...
any other suggestions....and how much or how long should i flush before attempting to fill the lines with ink
thankyou
d
 

·
Registered
Joined
·
2,654 Posts
maybe i need to buy all new dampers????
To verify that the dampers or lines are not clogged you can put a syringe in the end of them and try to draw ink from the bottles. If the ink is coming through slow or not at all it is in between the bottle and the dampers. If this is the case, remove the damper and try drawing through the line only - this will determine whether it is the damper or the line.

Hope this helps!
 

·
Registered
Joined
·
24 Posts
Discussion Starter #23
i think have that one figure out now - thankyou
but now after replacing all the dampers..i can not get a good nozzle head check and have run several head cleanings and it seems as though there is hardly any ink coming out

i do believe i'm a bit over this machine
 
21 - 25 of 25 Posts
Top