T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
Hi All.

I am having trouble with our Neoflex Bed!

We have had the machine for over a year now, and have been able to over come all issues, except this one.

When u turn the machine on and press start and the printer turns on moves to the back as normal, not for us atm!

It is not moving back at all and u have to mainly push the printer to the rear sensor and forward for it to complete its thing. other wise the printer will not clean.

had a sparky look st the motor of the bed and there is power getting to it and all sensors are working fine.

my question is, could there be a glitch were we have to reload the bed data or printer data for the bed to move back and forwards?

ps it still moves up and down.

please help and any thoughts would be good
thanks

*****
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top