T-Shirt Forums banner

Need help for dtf print

882 views 3 replies 4 participants last post by  into the T 
#1 ·
I have pressed this supacolor print on the left chest. and a square appears at the bottom where its pressed.
How to remove the square from the heat pressed .
Please suggest .
Your reply is very much appreciated.
Thank you.
Outerwear Green Sleeve T-shirt Aqua
 
See less See more
1
#3 ·
I have pressed this supacolor print on the left chest. and a square appears at the bottom where its pressed.
You have 2 squares.
A small one from the transfer film, and a larger one from the heat plate.
Using a soft edge pillow will eliminate the large box and reduce the visibility of the small one.

other alternatives are:
a) use cotton shirts only, or
b) use low heat transfers.

BUT ... why use supacolor for this?
This job looks like the perfect match for print-cut vinyl.
Siser Hi-5 for example can be pressed at 250F, avoiding the heat marks altogether.
 
#4 ·
did you see this on their website?

you will have to do some testing on pretty much every new garment that you use to dial in the settings

like mentioned above a pillow, a cover sheet of parchment that is larger than the heat platen, less pressure/time/temp,
until you can get a press that is properly adhered
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top