T-Shirt Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6,008 Posts
I would say the issue could be not enough pressure. If you are trimming the paper and the issue is near the edge.Then the paper could be trimmed to close and this would cause the design to bleed. .... JB
 

·
Registered
Joined
·
6,008 Posts
I think the issue could be, you are getting some dust particles on the mug and it 's causing you some issues. You need to make sure you wipe of the mug an the transfer before attaching the transfer to the mug. I think what your calling blistering is dust particles not allowing the ink to permeate the substrate. The fading could be the the fact that the transfer isn't on the mug tight enough or it could be more dust issues. I will say this is a tough form of decoration and takes a lot pf patience and perseverance to master. Good luck. .... JB
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top