T-Shirt Forums banner

My first 3 color print!

169 Views 2 Replies 3 Participants Last post by  760rdl
I finally got the chance to print my first 3 color design on the Ryonet Silver Press. I chose to print my logo on some scrap shirts to see how it would look. Let me know what you think!

P.S. - when I was on my fourth or fifth shirt, I started to get a build up of black in on the borders of the letters (underneath the emulsion). It gave the letters a much bolder and fuzzier look. I cannot seem to figure out why this is happening?!?!:confused:


See less See more
1 - 3 of 3 Posts
Looks good. Try doing less pressure and less squeegie angle when printing your black.
looks nice real nice...what type of press do you have
i too have had this happend

what i do is try not push to hard when i print and keep the off contact through the prints...

looks great like the design ......
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.