T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
2 Posts
Discussion Starter · #1 ·

I've recently invested in a 3d sublimation vacuum machine.

The problem I have is the silicone mug wraps keep splitting/breaking and I have no idea why.

At first we thought it was the machine as their were other faults with it so the company replaced it.

We went from 24 to 4 wraps in about a 6 print runs.

New machine and 8 new wraps and the same problem - we have reduced the temp to 180c and 10 minutes - yet still having the same issue.

Can someone help as this is getting expensive.:mad:
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.