T-Shirt Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
41 Posts
i just finish building the base using fiberboard using DIY DTG WIKI Cluebook and bought some skateboard wheels and 24" slider.
(i'll take some picture of the base tomorrow)
I have couple question.
1. What's the diameter of the R1900 drive motor shaft.
2. Anyone got picture of their friction drive setup i can see as reference.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top