T-Shirt Forums banner
1 - 18 of 35 Posts

· Registered
33 Posts
looks very cool... similar to the tjet3;).. it will have backlash but you can adjust it with the ek rip feed adjustment.. make sure the screw matches the pitch of the original drive rod .3125 or it will not match the epson firmware settings!!! I like any design that gets the job done for low cost:p
I live for it..lol and i could talk about allllll day!!!
This is my old t-jet! I try to modification
1 - 18 of 35 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.