T-Shirt Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
I have printed about 3 different jobs already and all of a sudden i coat a screen set it for two hours to day. I place my images on the screen and burn with a 250w halogen flood light exactly 19" from the screen surface for about 13 to 15 min. when I go to wash out the emulsion nothing washes out as if I burned the screen for an hour and over exposed. But again I only exposed for 13 to 15 min.

I did the same process four times with the same outcome.
Thinking there was something wrong with my emulsion I want and bought a new quart and got the exact same results.......

I will admit I did not degrease the screen at all... (shame on me)

Could this be the problem?
 

·
Premium Member
Joined
·
10,512 Posts
Are your film positives definitely the same opacity as before? Have you tested some of the film that previously exposed fine?
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top