T-Shirt Forums banner
1 - 5 of 5 Posts

· Registered
88 Posts
Discussion Starter · #5 ·
Many times metal thread is an problem.
You must make tests for :
Thread adjustments(upper & under)
Many machines have an parameter :
Frame angle start
Set to maximum value.
Yes, I am aware of this. However, the company's claim is "Unlike other metallic threads, the RAPOS cones are polyester core wrapped in Mylar. This makes them stronger so the thread does not break as often, eliminates metallic flaking of normal metallic thread cones, and runs smoothly through your embroidery machines."

So I'm looking for anyone that has worked with this specific brand.

Thanks again for your time in responding, much appreciated.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.