T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
235 Posts
Discussion Starter · #1 ·
Does anybody run a Merrow MG-3U that could provide some advice on tensions? I'm having trouble getting the lower looper thread to pull the upper looper (floss) thread around to the backside sufficiently. Right now I have the lower looper tension as high as I can get it. I also have the needle thread tension very high and the upper looper tension as loose as I can get it.

Any thoughts?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.