T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
60 Posts
Discussion Starter · #6 ·
Re: melted polyprop on my new maxx heat press

Turn it off - let it cool down - turn it on - with a teflon scraper as it warms up - carefully scrap it off - On sensitive materials use a teflon sheet, but hindsight is 20/20
from the rubber pad at the bottom? the top of the machine is fine once it cooled of it feel the polyprop material feel away from the top of the machine. I just need to know how clean the rubber pad on the bottom.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.