T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My Melco EMT 10T stopped in the middle of a design today with a alarm sound and the screen read: Missed Head Up.
We were able to shut it down, go to head up, do a power fail rescue and continue the design, but it did it again. We tried a hard reset, but it did it again after that.
What is going wrong? Is it a power supply problem? Motherboard? Any ideas?
HELP.
 

·
Registered
Joined
·
2 Posts
My Melco EMT 10T stopped in the middle of a design today with a alarm sound and the screen read: Missed Head Up.
We were able to shut it down, go to head up, do a power fail rescue and continue the design, but it did it again. We tried a hard reset, but it did it again after that.
What is going wrong? Is it a power supply problem? Motherboard? Any ideas?
HELP.
Hello, I have the same issue. Did you get what was going on?
 
1 - 2 of 2 Posts
Top