T-Shirt Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,090 Posts
Discussion Starter #1
What media type do you use to cut, Jet Opaque? With a Craftrobo. Mine cuts fine, just won't lift off backing with Magic Mask. Any thoughts. Thanks, Mike
 

·
Registered
Joined
·
2,090 Posts
Discussion Starter #3 (Edited)
Nick, part of the backing comes off on parts of the design when I peel it by hand, no mask, I've used Jet Pro before with Magic Mask, I can't remember which media type I used when it worked. I'm starting to think I could have got some bad paper from my supplier. It cuts heat applied vinyl fine, and it applies great. The vendor was'nt a lot of help, I order my paper from the same vendor each time. Thanks, Mike P.S. the scrap does seperate from the image I cut.
 
1 - 4 of 4 Posts
Top