[TopDogGraphix]

I'M WORKING OUT OF MY TRAILER BEFORE A SHOW IS 69DEGREES AND MY MASK IS NOT PICKING UP MY VINYL


SORRY THIS IS CHOPPY POSTING FROM MY PHONE

I'M
USING ORACAL 651 WHITE
AND R TAPE CONFORM


PLZ HELP

Sent from my EVO 3D using T-Shirt Forums

 

[Fenrir]

It's bad to install vinyl in cold temps but I don't think that's "too cold" yet. Make sure your vinyl is clean, it may have gotten greasy. Clean the surface with rubbing alcohol (put the alcohol on a rag, don't pour it on the vinyl) before masking. Also peel the backing off the vinyl, don't use the mask to lift it up. That really shouldn't be a hard combination to mask so I'm thinking the top of the vinyl is dirty or greasy somehow.

 

[TopDogGraphix]

ACTUALLY I THINK IT WAS THE COLD I DON'T REMEBER THE TEMP IT'S IN LAST POST I THINK 69DEGREES

BUT I TURNED ON MY LITTLE HEATER AND HEATED UP MY MASKED MATERIAL A LITTLE IT PEELED FINE

I HAVE WORKED WITH THESE MATERIALS BEFORE IN COLDER IN MY TRAILER

WITH NO PROBLEM

YA I RELISE ITS NOT GOOD SO IT IN COLD I WAS ONLY MAKING DECAL DISPLAYS FOR USE INDOOR TEMP SO NO HARM REALLY


Sent from my EVO 3D using T-Shirt Forums