T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I used to cut vinyl on a Roland SX-15 a decade and a half ago, primarily for automotive applications. Recently a project prompted me to look for a larger cutter for stencils, and I discovered all these forums that I was unaware of last time around. Since I benefited from a few posts here that I found through Google, I figured I'd register. And of course when registering, one is... "strongly encouraged" to post an introduction.

I might try some HTV this time. Even if I don't, there's always tips and info about equipment.

Y'all take care now.
--S.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top