T-Shirt Forums banner

Major starting issue

606 Views 0 Replies 1 Participant Last post by  allsorts5
Hi all,
I'm running a Graphtec CE5000-60 which I bought off a friend who had successfully used it for his business for a couple of years. He initially showed me how it worked by cutting me a lovely orange elephant sticker. So I know it worked and I've seen some of the garments he's printed over the years.
I'm running the software he gave me which is Vinylmaster Ltr from 2010 which he used fine.


My issue is this: When I send my artwork to the plotter to cut it increases in size to way bigger than the media loaded?!?!
Even though according to all my settings the image should be no bigger than 9.5 inch by 10.5 inch.


Any help would be greatly accepted. TIA
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top