T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hello,

So we ran into another problem with our used DTG.
The bed stopped loading or ejecting. I admittly push and pulled the bed a few times while working on it.

I did an encoder test and it does register on the control panels as the numbers change.
It does have the ability to move back and forth as we got it to do it a few times ( ejecting is pretty shakey when it does do it). but this is very rare.

Could it possible be a setting issue as we were playing in the self diagnosis menu for a bit.
Or mechanical (gears, please no), X motor, or something on a board (or whole main board), a new encoder strip is needed, something else?

Everything else seems to be working OK ( got it to load manually and did a print)

Any and all help is appreciated.
 
1 - 1 of 1 Posts
Top