T-Shirt Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Hey everyone- I'm looking at a used M&R Fusion dryer. 36" belt width, which is plenty for my single 6/6 manual press. 6 feet of heat, with 4 heat panels (some have only 3). The dryer also comes with a belt extension, not that it makes much of a difference for this.

Any experience running these with WB or discharge? We run all plastisol right now, but hope to start moving towards water based in the next 6 months.

Is this dryer going to be too short, without any forced air?

Thanks,
Chris
 
1 - 1 of 1 Posts
Top