[MLJ]

Hi, I used to have a macro installed on X3 where if I was cleaning up a piece of artwork I could select a series of nodes and press shift H or shift V to align all the selected nodes either Horizontally or vertically. It really sped up the clean up process. Then my hard drive crashed and I had to reload all my programs and I lost that macro. I have been searching the internet looking for it and can't find it now. It was a free macro when I originally got it. anyone know where I can find this macro again?

Thanks
Mark

 

[bungy]

See attachment for node align.
You probably know this already.

If you are computer savvy, try this thread - Is it possible to assign hotkey to these checkboxes through VBA? - OberonPlace.com Forums

Hope it helps.

 

[MLJ]

Thank You, I appreciate it.

 

[freebird1963]

check out macro monster.com ( I think thats it.)
Think one got released over there.

Mark

 

[MLJ]

Thanks I will try that.