T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
Hello I am in the planning process of starting up a home art studio shop for vinyl t-shirts, heat pressing etc. I am looking into a Summa D-120 48 inch for a lot less than the new item price. Is this a good cutter or is it just to overkill for what I need to do right now. Also how is there software. I am thinking that this might come in useful for branching out later on to car decals etc.

Last question if you where in the market would you buy one.

How it looks so far I would not be paying much more than for a entry level that has digital servos and Tangential Emulation mode.

?????
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top