T-Shirt Forums banner
1 - 14 of 14 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi All
i am new to Corell x5 and have been looking at it for about a week I must be numer than a twig but can not find out how to get lettering to go straight up or down I have looked high and low but cant fingure it out PLEASE HELP as all my hair is almost gone
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #9 ·
Thanks All
So if I get this right,
Letter - enter, letter - enter, hit center on the vertical alignment when done.

and this is the best way to do vertical lettering going down

but what if you want to do the same word but going up , mabee, stick them to a grig line then group them ??

I can't figure this one out. corell will take a word and twist it into a knot and it will look perfict in every way but there is no quick and easy icon to get it up or down

oh well thanks for the help Bob
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top