T-Shirt Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
101 Posts
Discussion Starter #1
I have the Laser point 24 it cuts most of my design right but in 3 spots it skips it was cutting fine I cut about 10 of the same. Can it be the blade even though most of it ?:confused:
 

·
Registered
Joined
·
19 Posts
Hey Robert, are you a member at the US Cutter forum? I would post my question over there if you are and if you're not, I would definitely join. They are a great bunch over there and are always willing to help with any problems. I too have the LP24 but haven't had any issue's with cutting so far.
 

·
Registered
Joined
·
101 Posts
Discussion Starter #4
It was leaving like a zipper cut. I increased the pressure and its cutting fine now. I got that info from the cutter forum.Thanks.
 
1 - 5 of 5 Posts
Top