T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
98 Posts
You might expect to pay approximately $100 less for a used Groove-E than a brand new one -- MAYBE a little less.

Regarding the aluminum you asked about -- do a test cut with a craft knife -- can you cut through it in about 3 passes? If not, then you probably will not be able to cut it with the Groove-E. Please remember, that this is only a rough way to estimate whether the cutter will cut your material.

Regarding the vinyl. There are quite a few places where you can purchase 12" wide vinyl.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top