T-Shirt Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
What's a "barley used" KNK Groove-e Electronic Die Cutter worth? (Looking to buy one.)

They have a pretty high cutting force and they do engraving. Does anyone know if they will cut .02 Dynasub Aluminum? (I'm thinking not, but curious).
 

·
Registered
Joined
·
19 Posts
Discussion Starter · #2 ·
Also, since they are only 13" wide does that pose a problem for finding vinyl? The majority of vinyl seems to be in the 15"+ widths. Thanks!
 

·
Registered
Joined
·
19 Posts
Discussion Starter · #4 ·
Thanks for the reply Brenda. So then the $400 I paid for an 8 month old barley used one with extra tips including an engraving tip, was a good buy. :) I appreciate the suggestion on the metal. I doubt I'll be able to cut it, but I look forward to trying to engrave on it.

Randy
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top