T-Shirt Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
Hi,

we started to get this problem with k3 and it's getting more and more frequent. Basically when it does purging in the middle of the print job it stops to print after it's done purging. Cost us 5 shirts in last run.

Sometimes it goes on ok, but sometimes it stops.

any ideas?

Thanks!
 

·
Registered
Joined
·
1,925 Posts
If it happens during ink cart reset it's probably fault of the reseter or the timing on the capping station.

If it happens out of nowhere it's probably rip fault (should reinstall) or the USB cord (to long - may try connecting directly to the main board), or Windows 7 or to little ram issue.
 
1 - 3 of 3 Posts
Top