T-Shirt Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hello all I just received my graphtec ce5000-60 and can't seem to know what am I doing wrong here I'm not new to cutters just owned the cheaper ones anyway my problem is when I cut letters it seems to leave extra material on the corners like little triangles everywhere theres a corner is there a setting to fix this images I cut are fine it's just letters
 

·
Registered
Joined
·
1,843 Posts
Is it just cutting little letters & numbers that is what I'm gathering? If so you you need to change your command, to do so put material in cutter hit enter when it stops hit pause button then hit previous
button until you see command, then hit the up arrow until it changes to hp command hit enter and you should be all set.
Hope this helps.
Mike
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top