[pebbles822]

I just pressed a design on a shirt using JetPro Sofstretch transfer paper and was going to apply rhinestones afterword using my rhinestone templete I made for the design. I was ready to press my rhinestone design on transfered design but noticed the transfered design on my shirt has stretched out of shape just enough that my rhinestone design does not match my ink jet transfer design anymore. How can I keep my JetPro Sofstretch transfer from stretching out of shape when I pull the paper off the shirt? Is there something special I need to be doing to keep my design on my shirt the correct size when I pull the paper off?

Thanks
Becky

 

[Twanabee]

Don't know what type of shirt you are using but streach the heck out of it before you press the JPSS. This should help. I don't do rhinestones but do apply vinyl after JPSS and find that this helps.

 

[pebbles822]

Thanks Chuck for your reply. I am using Gildan Ultra Blend 50/50 T-Shirt. I will give what you recommended a try tomorrow.

Thanks again.
Becky