T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
6 Posts
Discussion Starter · #1 ·
hey, so ive been having this issue where i set up the design to be printed in illustrator and after i print out the design from my epson sp 1400 onto exact inkjet film and place it to be exposed, the design doesnt fully come out on the screen. ive been using this capillary film that only needs a 2 minute exposure and ive had this issue a few times. for now ive had to rely on printing the design on 2 inkjet films and overlaying them but over time that can become wasteful especially if im using multiple colors. now ive checked my set up in illustrator a bunch of times before printing to make sure that im using my RIP setup, only printing 100% black, and that my dpi is as high as it'll allow me to print yet i keep having this issue. any ideas as to why?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.